Sony CPD-E215E - Manual (Page 11)

11
GB
Additional settings (SCREEN)
You can manually degauss (demagnetize) the screen, and adjust
the moire cancellation level.
1 Press the center of the control button.
The main MENU appears on the screen.
2 Move the control button m / M to highlight
SCREEN and press the center of the control button
again.
The SCREEN menu appears on the screen.
3 Move the control button m / M to select the desired
adjustment item.
Adjust the selected item according to the following
instructions.
x
Degaussing the screen
The monitor is automatically demagnetized when the power is
turned on.
To manually degauss the monitor, first move the
control button
m
/
M
to select (DEGAUSS). Then move
the control button , .
The screen is degaussed for about 5 seconds. If a second degauss
cycle is needed, allow a minimum interval of 20 minutes for the
best result.
x
Adjusting the moire *
If elliptical or wavy patterns appear on the screen, adjust the
moire cancellation level.
To adjust the amount of moire cancellation, first move
the control button
m
/
M
to select (CANCEL MOIRE).
Then move the control button < / , until the moire
effect is at a minimum.
* Moire is a type of natural interference which produces soft, wavy lines
on your screen. It may appear due to interference between the pattern
of the picture on the screen and the phosphor pitch pattern of the
monitor.
Resetting the adjustments
This monitor has the following three reset methods. Use the
RESET button to reset the adjustments.
x
Resetting a single adjustment item
Use the control button to select the adjustment item you want to
reset, and press the RESET button.
x
Resetting all of the adjustment data for the
current input signal
Press the RESET button when no menu is displayed on the screen.
Note that the following items are not reset by this method:
• on-screen menu language (page 7)
• picture’s rotation (page 10)
x
Resetting all of the adjustment data for all
input signals
Press and hold the RESET button for more than two seconds. All
of the adjustment data (except for the USER settings in the
COLOR menu) is reset to the factory preset levels.
Example of moire
RESET