Sony DX250 - Manual (Page 73)

Se
tti
ng
s an
d Ad
ju
st
me
n
ts
73 US
x [BLACK LEVEL]
Selects the black level (setup level) for the video
signals output from the jacks other than
COMPONENT VIDEO OUT.
x [BLACK LEVEL (COMPONENT OUT)]
Selects the black level (setup level) for the video
signals output from the COMPONENT VIDEO
OUT jacks.
You cannot select this and the setting is not
effective when the system outputs progressive
signal.
x [4:3 OUTPUT]
This setting is effective only when you set [TV
TYPE] in [SCREEN SETUP] to [16:9]
(page 72). Adjust this to watch 4:3 aspect ratio
progressive signals. If you can change the aspect
ratio on your progressive format (525p/625p)
compatible TV, change the setting on your TV,
not the system.
• This setting is effective only when “P AUTO
(PROGRESSIVE AUTO)” or “P VIDEO
(PROGRESSIVE VIDEO)” is selected by using
PROGRESSIVE (page 22).
[ON] Sets the black level of the output
signal to the standard level.
[OFF] Lowers the standard black level.
Use this when the picture becomes
too white.
[OFF] Sets the black level of the output
signal to the standard level.
[ON] Raise the standard black level.
Use this when the picture becomes
too black.
Note
[FULL] Select this when you can change
the aspect ratio on your TV.
[NORMAL] Select this when you cannot
change the aspect ratio on your
TV. Shows a 16:9 aspect ratio
signal with black bands on left and
right sides of the image.
16:9 aspect ratio TV