User instructions – Smeg KLVS50EB User Manual
Page 8
User instructions
ADJUSTING THE WATER SOFTENING SYSTEM
(available in all programs except the soak program)
The dishwasher is equipped with an electronic device for adjusting the water softening setting
according to the hardness of the water. To adjust the water softening setting, proceed as follows.
•
Keep the PROGRAM DELAY button (3) pressed for a few seconds, until the H.- symbol,
followed by the set value, appears on the 3-FIGURE DISPLAY (6).
•
The PROGRAM DELAY button (3) can be pressed again to select the most suitable hardness
value (h.-1, h.-2…h.-5). Refer to the "Water hardness table" to select the value.
•
To exit the programming mode press the START/PAUSE button (2) or do not touch the keypad
for 2 seconds to allow the system to exit the mode automatically.
WATER HARDNESS TABLE
WATER HARDNESS
German Degrees (°dH)
French Degrees (°dF)
SETTING
0 - 4
0 - 7
.h 0
5 - 15
8 - 25
.h 1
16 - 23
26 - 40
.h 2
24 - 31
41 - 60
.h 3
32 - 47
61 - 80
.h 4
48 - 58
81 - 100
.h 5
Contact your local water board for information on the hardness of your water supply.