Snapper 1733419 - Manual (Page 12)

Normal Removal &
Installation
10
Normal Removal & Installation
Collector Installation
Note: See previous pages for more detailed installation
and operation instructions if necessary.
1. Lift discharge deflector up (E, Figure 16).
2. Slide the notch of bracket (G) on to deflector hinge
rod (F).
3. Secure the front of lower chute (A) to carriage bolt
(D) using wing nut (B).
4. Mount the the channel assembly (A, Figure 17) into
hitch (D). Secure by inserting pin (C) into the right
side of hitch (D) and turning pin (C) counterclockwise
to lock in place.
5. Pivot cover (B) up. Install bags (E) with white bar (F)
towards the rear.
6. Slide discharge tube (J) into seal (L).
7. Attach the discharge tube (J) to boot (H) and secure
the tube by moving wire form (K) down over metal
puck (I).
A
F
B
Figure 16. Install Lower Discharge Chute 38” Free
Floating Mowers
A. Lower Chute
B. Wing Nut
C. Rubber Strap
D. Carriage Bolt
E. Discharge Deflector
F. Deflector Hinge Rod
G. Bracket
D
C
E
G