Sharp CP-G10000S - Manual (Page 33)

33
CD-G10000
CP-G10000S
T
a
pe Rec
ording
„ Various tape functions
Caution:
z To remove the cassette, press the button, and then open the
compartment.
z Before changing from one tape operation to another, press the
button.
z If a power failure occurs during tape operation, the tape head will
remain engaged with the tape and the cassette door will not
open. In this case, wait until the power is restored.
Recording on a cassette tape
Function Main unit Remote
control
Operation
Play Press in the stop
mode.
Stop Press in the playback,
fast forward or fast re-
wind mode.
Fast for-
ward/Fast
rewind Press in the playback
or stop mode.
(TAPE 2
only)
Before recording:
z When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
z SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
z The volume and sound controls can be adjusted with no effect
on the recorded signal (Variable Sound Monitor).
z For recording, use only normal tapes. Do not use metal or
CrO tapes.
z Recording can be operated in the TAPE 2 compartment only.
The TAPE 1 is for playback only.
Erase-prevention tab of cassette tapes:
z When recording on a cassette tape, make sure that the erase-
prevention tabs are not removed. Cassettes have removable
tabs that prevent accidental recording or erasing.
z To protect the recorded sound, remove the tab after recording.
Cover the tab hole with adhesive tape to record on the tape with-
out the tab.
Side A
Tab for side B Tab for side A