Sprint Nextel SPRINT PCS VISIO SCP-7000 - Manual (Page 164)

148 Section 2I: Using Sprint PCS Ready Link
Receiving a Sprint PCS Ready Link Call
To receive a Sprint PCS Ready Link call:
1. Make sure your phone’s Sprint PCS Ready Link mode is
enabled. (See “Setting Sprint PCS Ready Link Mode”on
page 140.)
2. When you receive a Sprint PCS Ready Link call from a
contact, “R-Link Call,”the contact’s name and the
Sprint PCS Ready Link number are displayed. (You do not
need to take any action to answer the call.)
Ⅲ
When you receive a group call, “Group Call,”the
group member’s name, and the Sprint PCS Ready
Link number are displayed.
Ⅲ
If nobody takes the floor for 20 seconds, the call will
be a missed Ready Link call.
3. If the person placing the call has kept the floor (held the
Ready Link/Memo button), you will see the contact’s
name and Sprint PCS Ready Link number along with “has
floor,”and you will hear the caller speaking.
4. When the caller finishes speaking and releases ,
you will see “Floor is open”on the display screen. Press
and hold
to take the floor and reply to the caller.
(You will see “You have floor”and hear a tone confirming
that you may speak.)
5. When the conversation is finished, press .
Note: You can change the volume and the speaker setting while a
Sprint PCS Ready Link call is activated.
Volume: Adjust the
voice volume by using or by pressing the navigation
key up or down (except when you are pressing and holding
). Speaker: Switch the speaker on or off by pressing
.
Tip: You can also receive a Sprint PCS Ready Link call with the
phone closed. Press and hold to take the floor when
the floor is open.