Soleus Air HC4-15-20 - Manual (Page 5)

OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet.
Only operate the heater when it is in the upright position.
1. To operate as a HEATER: Press the ON/OFF button on the control panel.
2. Once the heater is on, press the MODE button to choose the desired heat setting. The icon
on the display showing three wavy vertical lines is HIGH (1500 Watts), the icon showing
two wavy vertical lines is LOW (750 Watts), and the E icon is for ECO mode. In ECO
mode, the heater will heat to the set thermostat temperature, and then decrease the power
usage by 1/3 to save energy while still maintaining the set room temperature.
3. Press the ▲ & ▼ buttons to change the desired thermostat setting. The thermostat can be
set from 59 °F to 80°F. The heater will cycle on and off to maintain the set temperature in
the room. Set the heater to 80°F for continuous heat (unless the room temp. is above 80°F).
4. Press the SWING button to enable the oscillation mode. The heater will rotate left to right
to disperse heat throughout the room.
5. To operate the HUMIDIFIER: First, attach the humidifier spout to the hole on the top of
the unit. Next, Remove the water container from the back of the unit (when the unit is off)
and add water. Place the container back in the unit. Press the HUMID button to start/stop
the humidifier. You can use this function while the unit is in heater mode, or when heater
mode is off. NOTE: The ON/OFF button is for heater mode only.
6. Press the TIMER button to enact the Auto-off timer. This will automatically turn the unit off
when the alloted time has passed. Each press of the TIMER button will add 1 hour to the
5
SAFETY FEATURES
Polarized Plug
Warning: This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the
plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED PLUG.
Tip-Over Safety Switch
This heater equipped with tip-over safety switch located underneath the base of the heater
(SEE ILLUSTRATION ON PAGE 4). This switch must be pressed inward for the heater to
function properly. Some soft surfaces such as carpet may not be able to fully press in this
switch. For some soft surfaces, a hard flat object will need to be placed underneath the heater
for it to function properly.
PLEASE DO NOT TAPE OR GLUE THIS SWITCH.