Schneider Electric Communication Drivers - Manual (Page 49)

TSX FPC 10 ISA card
49
Advanced
configuration To access the advanced configuration screen use the commands
"File->Advanced Configuration" .
The following window is displayed:
The following table describes the different areas and buttons in the window.
Zone Description
I/O address Used to choose the address in the storage area with which the driver
can find the Fipway FPC10 module. This address must be included
between 100h and 3F0h and be identical to the address configured in
the module.
DMA channel Used to select the DMA resource shared by the driver and the module.
This information must be identical to that configured on the module.
Interrupt Used to select the interrupt shared by the driver and the communication
module. This information must be identical to that configured on the
module.
Mode Used to disable the driver by checking the "OFF" box. This is usually the
case for the second instance of the driver. (FIP02).
WorldFip Allows use of frames in WorldFip profile A format whose CRC
calculation complies with the IECSC65C105 standard.
Cancel button Used to return to the previous window.
By default button Used to configure the different areas with default parameters.
OK button Used to acknowledge the new configuration parameters.
OK
Cancel
By default
PRUC
Configuration FIP FPC SN - Advanced
I/O address 210h
DMA channel
World FIP
Channel 5
Channel 6
Channel 7
Interrupt
IRQ 10
IRQ 11
IRQ 15
IRQ 3
IRQ 5
Mode
On
Off
0