Sony VPL-AW10 - Manual (Page 57)

57
Others
9
Place a new air filter.
After removing the air filter, do not touch
the fan inside the projector.
10
Attach the air filter cover.
11
Wipe dust off the Ventilation
holes (intake) with a soft cloth.
The projector will not turn on unless the air
filter cover is securely closed.
12
Place the project back on its
original position.
13
Turn on the projector, then
select the desired setting item
on the Setup
menu. The
menu screen below will be
appeared.
14
Select “Yes”.
15
Select “OK”.
Do not put your hands into the lamp
replacement slot, and do not allow any liquid
or other objects into the slot to avoid
electrical shock or fire.
• Be sure to use an LMP-H160 Projector Lamp
for replacement. If you use lamps other than
the LMP-H160, the projector may
malfunction.
• Be sure to turn off the projector and unplug
the power cord before replacing the lamp,
then check the
? / 1 (On/standby) indicator
has already been turned off.
• The projector will not turn on unless the lamp
is securely installed in place.
• The projector will not turn on unless the lamp
cover are securely closed.
• To cancel a message displayed on the screen,
press either the button on the remote control
or the one on the control panel on the
projector.
Note
Note
Ventilation holes (intake)
Caution
Notes
Note
The lamp contains mercury. The disposal
rules for used fluorescent tubes depend on
where you live. Follow the waste disposal
policy in your area.