Sub-Zero 424/O - Manual (Page 30)

30
M O D E L 4 3 0 I N S T A L L A T I O N I N S T R U C T I O N S
Glass
Gasket
Rail or Stile
Rout to 1 / 4 " (6) thickness
Glass
Gasket
13 / 32 " (11)
Diameter
1 / 4 " (6)
Diameter
Illus. 11 Illus. 12
OV E R L AY D O O R P A N E L
If your customer has chosen an overlay design
door and grille panel, the unit will be shipped
without handle and hardware. The cabinet
manufacturer or designer will provide handle
hardware at the job site to match the overall
decorating scheme. We recommend larger D-
style pulls. The use of small, one-piece knobs
is not recommended.
The metal frame on the glass door has
numerous mounting holes on each side of the
door. This is to accommodate the Sub-Zero
accessory handles and provide for easy attach-
ment of the handle through the door frame.
If you choose not to use these pre-drilled
mounting holes, you must either drill addi-
tional holes through the metal frame of the
door, or attach the handle through the door
panel only.
If you attach through the door panel only, the
handle must be attached before the door panel
is installed and the handle screws will need to
be set into the rear surface of the door panel.
If you choose to drill through the metal door
frame, this must be done before the handle
holes are located and drilled in the panel.
Illustration 12 shows how this hole passes
through the door frame. The hole center is on
the small locator groove in the front of the
frame. A
1 / 4 " (6) diameter hole is made in the
front wall of the extrusion and a 13 /
32
" (11)
diameter hole through the rest of the frame.
F R A M E D D O O R P A N E L
Install the #8 x 5 / 8 " screws through the back of
the glass door frame into the door panel. Refer
to illustration 11 below.
IMPORTANT NOTE: The door panel should
not be relied on to remain straight and flat by
itself. Secure it to the wine storage unit door
with the screws provided.
After the door panel installation is complete,
apply the cover patches or plugs provided over
the holes on the inside surface of the door.
The cover patches or plugs are part of the
insulation system on the door of the Wine
Storage unit. Be sure to cover all the
holes in the door that were used.
M O D E L 4 3 0
P A N E L
D E S I G N
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.
Dimensions in parentheses are in
millimeters unless otherwise specified.