Adjusting volume settings, Alert notification – Sanyo SCP-2700 User Manual
Page 44
32
2B. Settings
Adjusting Volume Settings
Adjust your phone’s volume settings to suit your needs and
your environment.
1.
Press
> Settings > Sounds > Volume.
2.
Select Ringer,Earpiece,Headset, Speakerphone,
Applications, or Start Up/Power Off.
3.
Press the navigation key left or right to choose a volume
level and press DONE (left softkey).
You can set the alert volume separately from the ringer volume
setting.
1.
Press
> Settings > Sounds > Volume >
Advanced...
2.
Select Alarms, Text Message, Picture Msg, or
Voicemail.
3.
Select Separate Volume.
4.
Select a volume level, and press DONE (left softkey).
Alert Notification
Set your phone to alert you with an audible tone when you
change service areas, once a minute during a voice call, or
when a call has been connected.
1.
Press
> Settings > Sounds > Alerts.
2.
Select Beep Each Minute, Out of Service, Connect, or
Signal Fade/Call Drop.
3.
Select On or Off.
Tip
You can make the alert vibrate at any volume level by
checking Always Vibrate.
Tip
You can adjust the ringer volume in standby mode (or
the earpiece volume during a call) by using the volume
button on the left side of your phone.
You can make your phone vibrate at any volume level by
checking Always Vibrate.