Schumacher Automatic XM1-5 User Manual
Page 13
• 12 •
MOViNG ANd STORAGE iNSTRUCTiONS
15.
Store the charger unplugged, in an upright position. The cord will
15.1
still conduct electricity until it is unplugged from the outlet.
Store inside, in a cool, dry place (unless you’re using an on-board
15.2
Marine Charger).
Do not store the clips clipped together, on or around metal, or
15.3
clipped to cables.
If the charger is moved around the shop or transported to another location,
15.4
take care to avoid/prevent damage to the cords, clips and charger. Failure
to do so could result in personal injury or property damage.
TROUBLESHOOTiNG
16.
PROBLEM
POSSiBLE CAUSE
REASON/SOLUTiON
Charger will not turn
on when properly
connected.
AC outlet is dead.
AC POWER LED is
not lit.
Poor electrical
connection. AC
POWER LED is not lit.
Severely discharged,
but otherwise good,
battery.
Clips are not making
a good connection
to the battery.
CONNECTED LED is
not lit.
Check for an open
fuse or circuit breaker
supplying the AC outlet.
Check the power cord
and extension cord for
a loose fitting plug.
The battery may not
want to accept a
charge due to a run-
down state. Allow the
charging to continue
until the battery has had
a chance to recover
sufficiently enough to
take a charge. If more
than 20 minutes, stop
charging and have the
battery checked.
Check for poor
connection to battery
and frame. Make sure
connection points are
clean. Rock clips back
and forth for a better
connection.