Smeg DWI409C - Manual (Page 6)

Installation instructions
36
The dishwasher can also be connected to a hot water supply not
exceeding 60°C. Supplying the appliance with hot water cuts down the
washing time by approximately 20 minutes, but slightly reduces its
effectiveness. Make the connection to the domestic hot water supply
using the same procedure described for connecting to the cold water
supply.
DRAIN CONNECTION
Insert the dishwasher’s drain
hose into a drain pipe having a
diameter of at least 4 cm, or
alternatively, place it inside the
kitchen sink using the plastic
support provided, taking care not
to crush or excessively bend the
hose. It is important to prevent
the hose from coming loose and
falling. For this purpose, the
plastic support is equipped with a
hole for tying it to the wall or
water tap.
The free end should be positioned at a height of between 30 and 100
cm, and should never be submerged in water.
If a horizontal drain extension hose is used (for a maximum of 3 m) the
drain hose can be placed at a maximum height of 85 cm from the
ground.
2.2 Electrical connection
Plug the power cord into a suitable electrical outlet, according to the
instructions given in chapter "1. Safety and operating instructions".