Scientific Atlanta EPX2203 - Manual (Page 36)

4004041 Rev A WebSTAR DPX2203 or EPX2203 VoIP Cable Modem User’s Guide 35
Telephone Service: Install the Cable Modem, Continued
Installing the Cable Modem
Follow these steps to install the cable modem to provide telephone service.
1. Connect a telephone, fax machine, or analog modem to each of the
appropriate RJ-11 ports on the cable modem.
Notes:
• The cable modem provides one line of telephone service on each of the
RJ-11 connectors.
• Service must be set up and enabled by the cable telephone service
provider.
• The two center conductors (pins 3 and 4) on the RJ-11 connector provide
electrical connections to directly attached telephone devices or to a
permanently installed in-home telephone wiring network.
• The telephone port labeled Line 1 also supports multi-line telephone
devices. Line 1 is supported on pins 3 and 4, and Line 2 is supported on
pins 2 and 5.
• The use of telephones that require electrical connections to other RJ-11
pins requires an adapter.
2. After all telephone connections are complete, insert the AC power adapter
cord into the DC power connector on the back of the cable modem, and then
plug the power adapter into an AC power source.
3. Connect the active RF coaxial cable to the CABLE IN connector on the back of
the cable modem.
Note: Use an optional cable signal splitter to add a TV, a DHCT or set-top
converter, or a VCR.
4. The cable modem begins an automatic search to locate and sign on to the
network that provides the telephone service.
Note: This process may take up to 5 minutes. The modem will be ready for
use when the CABLE light on the front panel stops blinking and illuminates
continuously.
5. Test your telephone service by lifting the receiver of each attached telephone
to verify that dial tone can be heard and that you can make and receive
telephone calls.
Note: The Line 1 or the Line 2 front panel light also illuminates when the
attached device is “off the hook.”