Sunrise Medical One-Arm Drive Quickie TS - Manual (Page 6)

930331 Rev. F 11 930331 Rev. F 10
V . A D J U S T M E N T S V . A D J U S T M E N T S
4. Quickie TS (Fig. 14)
Quickie IRIS (Fig. 15)
a. The center of gravity is adjusted by
moving the rear axle forward or back-
ward to the additional holes located
along the frame.
b. Rotating the entire axle brackets allows
the user to use different wheel sizes
and often different seat heights.
C. REMOVAL AND INSTALLATION
OF DRIVE SHAFT ASSEMBLY
1. Installation (Fig. 16 & 16a)
a. Compress, twist and lock the drive shaft
assembly.
b. Insert one end of the drive shaft assem-
bly into one of the axle tabs.
c. Unlock the drive shaft assembly and
insert it into the opposite axle tab.
2. Removal
a. Compress, twist and lock the drive shaft
assembly.
b. Remove one end of the drive shaft
assembly from one of the axle tabs.
c. Remove the drive shaft assembly from
the opposite axle tab.
d. Unlock the drive shaft assembly and
store it in the drive shaft mounting
brackets.
D. STORAGE OF DRIVE SHAFT
ASSEMBLY
a. Drive shaft mounting (storage) brackets
are mounted on the lower front frame
and lower rear frame or on opposite
ends of a crossbrace.
NOTE: On Zippie GS, drive shaft assembly may be
stored on lower frame only.
b. The drive shaft assembly may be placed
in these brackets and stored
for easy access.
E. REVERSING ONE-ARM DRIVE
MOUNTING SIDES
a The one-arm drive may be mounted on
either side of the chair.
b Follow one-arm drive assembly instruc-
tions in reverse order to disassemble.
c. To remount on opposite side follow
one-arm drive assembly instructions.
F. USE OF ONE-ARM DRIVE
Keep hand clear of center of the wheel or
spokes when propelling the one-arm drive.
This may cause a pinch or crush-type injury.
1. One-Arm Drive Operation
a. To propel both wheels forward, push
both the outer and inner handrim on
the side the one arm drive is mounted.
b. If the outer handrim is mounted on the
right, push the outer handrim to turn
the chair to the right. (Reverse this
instruction if the outer handrim is
mounted on the left.)
c. If the outer handrim is on the right, push
the inner handrim only to turn the chair
to the left. (Reverse this instruction if the
outer handrim is mounted on the right.)
Fig. 16
Fig. 16a (Quickie TS)
Fig. 14
Fig. 15
a
b