Smeg ST1146SE - Manual (Page 5)

User instructions
22
Assisted programming (Wizard)
x Press (D) or (E) in repetition to display
the type of dirt on the dishes, on the top
line of the DISPLAY (G).
x Press (B) or (C) to confirm the selection and continue programming.
Choose the type of wash following the procedures described above (D or
E to display the selections available, B or C to confirm).
At the end of assisted programming, the DISPLAY (G) shows "Wait
please..." and a few seconds later you will be offered the option
selection function (button B/C to accept, D/E to reject).
Refer to the "OPTIONS" section to view the possibilities available.
Standard programming
Select "No" (key B) to disable assisted programming and the system
will offer the last program performed.
To start this program, simply close the door (buzzer sounds, if
enabled).
To select another program, press (B) in repetition until the program
required is displayed; to start this program close the door (buzzer
sounds, if enabled).
See TABLE OF PROGRAMS on following pages.
At the end of the assisted or standard
programming procedure, the programmed
duration of the washing cycle, in minutes,
appears on the bottom line of the DISPLAY
(G).
x The temperature which appears before the program's name
indicates its type (e.g. 45° delicate programs, 55° economy, 65°
intensive, etc.); the actual temperature is displayed, stage by stage,
while washing is in progress.
x Programs' duration, temperature and consumption figures are
guideline, since they depend on various factors, such as type of
load, intake water temperature, room temperature, etc.