Samson RB2030 - Manual (Page 2)

Introduction
Thank you for purchasing the Samson RB2030 Rechargeable Battery for
Expedition EX20 and EX30 cabinets. The RB2030 incorporates four 12VDC,
3.3A Gel Cells. A fully charged RB2030 should supply power to the EX20 or
EX30 for 4–5 hours.
With proper care, your RB2030 will operate trouble free for many years. Please
read the instructions carefully and note that your battery has been shipped
uncharged.
Parts List
RB2030 Gel Cell Battery 1
M4 x 14 Screws 2
M6 x 12 Screws 2
Charging the Battery
Before using the RB2030, the Battery must be fully charged. After following the
instructions for installation, connect the EX20 or EX30 to an outlet and turn the
unit on. The battery will take 6–8 hours to fully charge. The battery level meter
on the rear panel of your EX20 or EX30 will show a level only when the AC cord
is disconnected.
M6 x 16
M4 x10
Thumb
Screw
figure 1 figure 2
M4 x 10
M6 x 12
M4 x 14