Snapper 9265 - Manual (Page 12)

12
Section 3 - MAINTENANCE
3.4 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in the
maintenance schedule.
3.4.1. Engine
Refer to engine owner’s manual for service
instructions.
3.4.2. Spark Plug
Refer to engine owner’s manual for service
instructions.
3.5 STORAGE
PROCEDURE
Refer to the Engine Owner’s Manual for directions
regarding engine storage preparations. Prepare the snow
thrower for “end of season” storage as follows:
1. Drain fuel from fuel tank and let engine run until
all fuel is out of the carburetor.
2. Disconnect and remove the spark plug wire
away from spark plug before any other
preparations are made!
3. Tape all openings closed to prevent spraying
water into exhaust or air intakes during washing.
4. Tilt snow thrower up on its wheels and
thoroughly clean the underside of the
auger/impeller.
5. Lubricate all exposed metal with a light coating
of oil to prevent corrosion.
6. Store the machine in a shed or other dry area,
protected from weather.
3.6 MAINTENANCE and SERVICE PARTS
MAINTENANCE and SERVICE PARTS
Auger Drive Belt (Briggs Engines) 1-3937
Auger Drive Belt (Tecumseh Engines) 1-3939
Wheel Drive Belt (Briggs Engines) 1-3936
Wheel Drive Belt (Tecumseh Engines) 2-9101
Scraper Blade (24” Width Auger) 3-6122
Scraper Blade (26” Width Auger) 3-9770
Scraper Blade (30” Width Auger) 3-6006
Rubber Drive Tire 1-0765
Shear Bolts - 5/16-18 x 1-7/8”
Hex Nuts - 5/16-18 9-1550
9-1298
Parts Manual for Large Frame Snow Throwers - Series 5
Models: 8245, 8265, E8265, 9265, E9265, 10305, E10305,
10305E, E10305E, N10305E
#06037