Sound Performance Lab 9631 - Manual (Page 12)

12
Spectralizer
Control Elements
If you want to apply various presets depress A PPLY for one
second. The A PPLY LED starts to flash indicating that the A PPLY
mode is activated. You can step through the preset list with U P
and D
OWN
. Once you have a preset that you want to apply
depress A PPLY again. The A PPLY LED goes out indicating that the
preset is applied.
In case you want to quit the A PPLY mode without applying the
new preset simply press S TORE .
To increase operation safety it is impossible to apply presets
by simply depressing U P or D OWN . The U P and D OWN status-
LEDs will not flash indicating that the input is not accepted. You
have to depress S
TORE or A PPLY for one second in order to
activate the U P and D OWN buttons.
Depressing S TORE and A PPLY simultanouesly for about one
second gets you into a hardware dialogue, called I NFO . The LC-
display shows status informations of the digital data stream.
With U
P /D OWN you will jump from one page to the next or
previous. If a selection is provided use A PPLY to select.
1. Software version and date
2. Selecting inputs:
The S PECTRALIZER automatically searches for an input signal. If
both inputs are connected the AES/EBU input will be selected
first. If you want to select the S/P-DIF input you have to call up
the I
NFO pages.
AES/EBU input detected
or:
no AES/EBU input detected
Press A PPLY (if AES/EBU is detected):
AES/EBU input with wordclock detected
Applying a preset:
Depress A
PPLY for1 sec.,
LED flashes;
use U
P /D OWN to select
preset no.;
depress A
PPLY again,
LED goes out
Operation safety:
Presets can not be changed
by accident
Info 12