Silvercrest SKM550EDSA1-06/10-V3 - Manual (Page 9)

- 7 -
Cleaning and care
Risk of electrical shocks.
Before cleaning, remove the mains power plug!
Otherwise, there is the great risk of receiving an
electric shock!
Warning: Never submerse the appliance in
water or other liquids.
Attention!
DO NOT use any abrasive cleaning agents. These
could damage the upper surfaces of the appliance!
Note: To prevent the drying-on of food rem-
nants, ALWAYS clean the appliance and all
parts used immediately after use.
Note: After the processing of colour-rich foods,
such as carrots, the plastic parts could become
discoloured. These discolourations can be
removed with a little cooking oil.
Wipe the appliance with a damp cloth. If necessa-
ry, use a mild detergent.
Afterwards, dry the appliance completely.
Cleaning the mixing bowl y , food processor u ,
lid with stodger d and accessories
Clean all accessories, the mixing bowl y , the food
processor u and the appendant lid with stodger d
in water with a little detergent. Possible residues can
be removed with a dishwashing brush. Rinse with
clear warm water and dry them well.
The accessories, the mixing bowl
y , the food pro-
cessor u and the appendant lid with stodger d are
NOT suitable for cleaning in a dishwasher. Cleaning
the accessories, the mixing bowl
y , the food pro-
cessor u and the appendant lid with stodger d in
a dishwasher will cause irreparable damage to
them.
Cleaning the mixer
Risk of injury from the sharp knife!
Do not handle the mixer knife with bare hands.
Attention!
DO NOT use any abrasive cleaning agents.
For cleaning, put some water with detergent into
the assembled for use mixer
r .
For cleaning, pour some water with a little deter-
gent into the already fitted blender
r .
Press the lid with funnel on such that the lid locks
firmly into place.
Switch the mixer
r on for a few seconds. Pour out
the cleaning solution and then rinse the mixer r
with clear water. Possible residues can be removed
with a dishwashing brush.
The mixer
r is NOT suitable for cleaning in a dish-
washer. Cleaning it in a dishwasher will cause irre-
parable damage to the mixer
r .
Troubleshooting
If the appliance suddenly ceases operation:
The appliance has overheated and triggered the
automatic safety switch-off.
• Place the rotary switch
g at 0.
• Remove the plug from the wall socket.
• Allow the appliance to cool for 15 minutes.
• If, after 15 minutes, the appliance has not yet
cooled off completely, it will not start.
• Wait a further 15 minutes and try switching on
again.
If the appliance does not switch itself on:
• Check to see if the plug is in the power socket.
• Check to see if the drive protection lids for the
mixer r and food processor u , the mixing
bowl y and the lid are correctly placed and
properly engaged.
• Check to see if the swivel arm h is in the required
position (see chapter „Operating positions“).