Snapper 1695299 - Manual (Page 5)

5
54” Turbo Blower
Installation Instructions
Install Deflector
1. Locate the taptite screw (A, Figure 3) securing the
inner right-hand belt cover spring clip (C). Remove
the taptite screw (A).
2. Install the spring anchor (B) above the belt cover clip
(C) and secure using the original taptite screw (A).
3. Install the new right hand belt cover assembly (E)
using the original taptite screws removed in Step 1.
4. Assemble the hinge rod (B, Figure 4) and hinge
bracket (F). Secure using the rod anchors (A), 1/4-20
x 5/8 capscrews (E), lockwashers, and nuts as
shown.
5. Drill four 13/64” holes at the marked locations on the
underside of the deflector assembly (E, Figure 5).
6. Secure the deflector (C, Figure 5) to the deflector
hinge assembly (B) using four 10-24 x 3/4 truss head
screws (D) and nylock nuts (A). Insert the screws
from the bottom.
Figure 3. Install Cover & Spring Anchor
A. Taptite Screw
D. Roller Bar Retainer
B. Spring Anchor E. New Arbor Cover Assy.
C. Cover Clip
Figure 4. Assemble Hinge
A. Rod Anchors
D. 1/4-20 Nut
B. Hinge Rod E. 1/4-20 x 5/8 Capscrew
C. 1/4” Lockwasher F. Hinge Bracket
A
Figure 5. Assemble Deflector
A. 10-24 Locknut
B. Hinge Assembly
C. Deflector
D. 10-24 x 3/4 Truss Head Screw
E. 13/64 Holes
A
B
C
D
E
B
E
C
D
A
B
E
E
F
C
D
D
C