Snapper EI55223 - Manual (Page 18)

18
Section 4 - REPAIR & ADJUSTMENTS
4.1.8. SINGLE HANDLE CONTROL ADJUSTMENT
(7 HP Models Only)
IMPORTANT: Standing in the operator’s position, the
left handle bar lever is for wheel drive engagement and
disengagement. The right handle bar lever is for
auger/impeller engagement and disengagement. Hold
both levers down to handle bar for engagement and
release levers for disengagement. When both levers
are pressed down to the handle bar at the same time,
the operator can release the right hand lever and the
right lever will remain engaged as long as the left hand
lever is held down to handle bar. Release the left hand
lever and both levers will disengage.
1. Hold the wheel drive control lever down against the
handle. See Figure 4.12.
2. Check position of the cam lock. It must align with
the adjusting line located on the cam lock bracket.
3. To adjust, loosen the nuts on the cable guide
support bracket and move the bracket in or out until
the cam lock aligns with the adjusting line. Retighten
nuts.
4. Hold the wheel drive control lever down to the
handle bar, at the same time press the auger/impeller
control lever down to the handle bar and hold in
position.
5. Check the position of the cable ferrule in relation to
the cam lock. The ferrule must be located 1/16” (.060)
above the hook of the cam lock. To adjust, loosen the
three nuts that secure the cam lock bracket. Slide
bracket up or down until correct measurement is
achieved. Retighten nuts securely. See Figure 4.12.
FIGURE 4.12
HOLD DOWN
HOLD DOWN
TRACTION CLUTCH
CONTROL LEVER
BLOWER CLUTCH
CONTROL LEVER
(L.H. SIDE) (R.H. SIDE)
CABLE
CAM LOCK
CABLE FERRULE
. 060
(1/16”)
CABLE
CAM LOCK
HOOK
ADJUSTMENT LINE
(ON BRACKET)
DOWN
UP
CAM LOCK
BRACKET
IN
OUT
CABLE
GUIDE
CABLE GUIDE
SUPPORT
BRACKET