Symbol Technologies CDM-8910WW - Manual (Page 29)

SETTINGS SETTINGS
C
H
4
57
C
H
4
56
Controls the Ringer, Key Tone, Voice Call and Speakerphone volume.
VOLUME
RINGER
1 Press [MENU] .
2 Select one of the following options by
pressing the Navigation Key to the right.
3 To confirm, press [OK].
1 Press [MENU] .
Silent : Mute the ringer, press (Min).
Ringer Off
Vibrate On
Ringer Mode : Up & Down (Level 1~5)
High & Vib : The ringer sounds after vibration,
press (Max).
To adjust key pad tone:
Controls the Ringer volume and alerts you to incoming calls in the
modes listed in the gray box below.
KEY TONE
2 Adjust the key pad tone with the Navigation Key.
3 To activate, press [OK].
1 Press [MENU] .
To adjust earpiece volume (Lets you adjust the ringer volume in
standby mode with side volume key):
VOICE CALL
2 Adjust the earpiece volume with the Navigation Key.
3 To activate, press [OK].
Level 1 - 5 (Min- , Max- )
Off (Min- )
Level 1 - 5 (level 5, Max- )
When set, this setting alerts you to the following handset changes:
Sounds an alert every minute during a call.
ALERT
MINUTE
2 Select “Off” or “On” with the Navigation Key, then
press [OK] to activate it.
1 Press [MENU] .
Sounds an alert when leaving a service area and entering a roaming
service area.
ROAM
2 Select “Off” or “On” with the Navigation Key, then
press [OK] to activate it.
1 Press [MENU] .
Notifies you that a call has been successfully placed.
CONNECT
2 Select “Off” or “On” with the Navigation Key, then
press [OK] to activate it.
1 Press [MENU] .
1 Press [MENU] .
To adjust speakerphone volume:
SPEAKERPHONE
2 Adjusts the speakerphone volume using the
Navigation Key.
3 To activate, press [OK].
Level 1 - 5 (Min- , Max- )