Interface settings – Sharp TINSE2026QSZZ User Manual

Page 114

Advertising
background image

112

SYSTEM SETTINGS (ADMINISTRATOR)

INTERFACE SETTINGS

The "INTERFACE SETTINGS" are used to monitor
and set limits for the data that is sent to the machine’s
USB port or network port. The settings consist of the
following programs:

● HEXADECIMAL DUMP MODE

● I/O TIMEOUT

● USB PORT EMULATION SWITCHING

● NETWORK PORT EMULATION SWITCHING

● PORT SWITCHING METHOD

● ENABLE USB PORT

● ENABLE NETWORK PORT

HEXADECIMAL DUMP MODE

(When the PRINTER EXPANSION KIT is installed)

This program is used to print out the print data from the
computer in hexadecimal and in the corresponding text
characters (based on ASCII code). This allows you to
check whether or not print data is being correctly sent
from the computer.
This program is initially disabled (factory default
setting).

Example of output in hexadecimal dump mode (A4
portrait)

I/O TIMEOUT

This program is used to set the amount of time until I/O
timeout when waiting for print data.
In the event that the set amount of time elapses
without the port receiving any print data, the I/O
timeout function temporarily breaks the port
connection and intiates automatic port selection or
makes the port begin waiting for the next set of print
data.
The factory default settings are as follows:

• 180 (sec.)
• When the PRINTER EXPANSION KIT is installed:

60 (sec.)

USB PORT EMULATION SWITCHING

(When the PRINTER EXPANSION KIT is installed)

This program is used to set the printer language when
the machine is connected using the USB port.
The factory default setting is "PCL*".
* When the PS3 expansion kit is installed, the setting is

"AUTO".

Unless printing errors occur frequently, it is
recommended that the setting be kept at "AUTO".

NETWORK PORT EMULATION
SWITCHING

(When the PRINTER EXPANSION KIT is installed)

This program is used to set the printer language when
the machine is connected using the USB port. The
selections are the same as for "USB PORT
EMULATION SWITCHING".
The factory default setting is "AUTO".

Unless printing errors occur frequently, it is
recommended that the setting be kept at "AUTO".

Selections

Description

AUTO

The printer language is
automatically changed to match
the data received from the
computer.

PostScript
(When the PS3
EXPANSION
KIT is installed)

The data received from the
computer is printed using
PostScript.

PCL

The data received from the
computer is printed using PCL.

MX-M310.book 112 ページ 2009年7月6日 月曜日 午後6時57分

Advertising