Sampo DR-S0426 - Manual (Page 18)

16
PLAYBACK TYPE SELECT
>TIME SEARCH
EVENT LIST
EXIT
PRESS [UP，DOWN] TO MOVE [MENU] TO EXIT
[RIGHT,LEFT] TO SELECT
CHAPTER 4
OPERATION PROCEDURES
1 Getting Started with your machine
Please assure the following instructions before you switch on the machine:
1.1 Voltage check: Before power cable is connected, please check the voltage of this
appliance against the supply.
Input voltage range 100~240V, frequency range 47-63Hz.
CAUTION - Damage would be caused if incorrect power voltage applied.
1.2 Hard Disk connection: Make sure the 40-Pin Hard Disk Data cable and the 4-Pin
power connectors are properly connected.
2 Recording
2.1 Press the REC key to enter the Recording Mode. And press the STOP key to
stop recording.
2.2 On information bar the "MUX" or "QUAD sign will be indicated on the screen, it
means you select MUX or QUAD recording.
2.3 "15P" sign will be indicated in top right corner on the screen, it mean the
recording speed you selected. 15P means 15 fields per second.
2.4 O" sign will be indicated in center corner on the screen, it means the marked
channel is recorded.
2.5 For more information on Setting up Recording Mode, refer to Chapter 3 Record
Setup
2.6 In Recording Mode, if there is a power failure or power lost for any reasons that
cause a shut down of this machine, it will be back to the Recording Mode
automatically when power restored.
3 Playback
Press the ►PLAY button to
into playback mode, There
are two ways for searching
for video records, use "▲"
or "▼" key to select a way
for searching, there are two
selections "TIME SEARCH"
and "EVENT LIST". Arrow
mark ">" indicates current
selection, press "◄" or "►"
key to start the search.