SLS Audio HT805S - Manual (Page 7)

HT805 Series Owner’s Manual Page 7
Audio Connection (cont.)
The HT805W subwoofer will accept both line level signals via RCA jacks or speaker level signals from an amplifier
via the binding posts. Do not use a mixture of line level and speaker level connections. Whenever possible, use
the line level connections.
Input received from dedicated subwoofer
output on source electronics or a line level
normal stereo output. A dedicated
subwoofer output can use either the left
or right inputs.
Unaltered pass-through output signal (exactly
matches input signal) Used for optional
additional subwoofers or in the case of a line
level stereo output, they would go to the input
of the amplifer for the satellites
Use of the Full Range setting uses your receiver - proces-
sor to control the crossover point between the subwoofer
and satellites. Alternatively, use the Low Pass when
connected to a normal stereo output or when your
receiver - processor settings give unsatifactory results.
Low Pass will engage the crossover knob for high
frequency cut-off adjustment (typically set around 80Hz
when used with the HT Series Satellites)
Power switch for subwoofer
“On” will always apply power, “Auto” will
engage the sense circuit turning off the
subwoofer when no signal is present after a
period of about 5 mins. When signal is
present at the inputs, the subwoofer will
automatically turn on.
80Hz high pass filtered output signal
(goes directly to satellite speakers)
Alternate input (from amplifier powering
stereo pair of speakers)
Line Voltage Selector Switch
1650 W. Jackson Ozark, MO 65721 (417) 883-4549 Rev: 602
Continuously variable phase control.
Adjustments can provide a better blend
between the subwoofer and satellites
when they are remotely located from each
other.
Volume adjustment of subwoofer used to
blend in with the satellites
Fuse Holder