Preparation, Using the remote control unit, Cautions regarding remote control unit – Sharp AQUOS 9JDJ3BX0131A User Manual

Page 14: Antennas

Advertising
background image

12

F-type connector should be

fingertightened only.

When connecting the RF cable to the TV set, do not tighten

F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The

breaking of internal circuit, etc.)

1. A 75-ohm system is generally a round cable with F-type

connector that can easily be attached to a terminal

without tools (Commercially available).

2. A 300-ohm system is a flat “twin-lead” cable that can be

attached to a 75-ohm terminal through a 300/75-ohm

adapter (Commercially available).

Using the remote control unit

Use the remote control unit by pointing it towards the remote control sensor on

the TV. Objects between the remote control unit and the remote control sensor

may prevent proper operation.

Cautions regarding remote control unit

• Do not expose the remote control unit to shock.

In addition, do not expose the remote control unit to liquids, and do not place in an area

with high humidity.

• Do not install or place the remote control unit under direct sunlight. The heat may cause

deformation of the remote control unit.

• The remote control unit may not work properly if the remote control sensor on the TV is

under direct sunlight or strong lighting. In such cases, change the angle of the lighting or

the TV, or operate the remote control unit closer to the remote control sensor.

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of

connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an

F-type connector, plug it into the antenna terminal at the rear of the TV set.

Preparation

300-ohm twin-lead cable (flat)

F-type connector

75-ohm coaxial cable (round)

F-type connector

75-ohm coaxial cable

NOTICE

Connecting Antenna Cable

Cable without a

CATV converter

Combination VHF/

UHF antenna

Separate VHF/

UHF antenna

VHF/UHF antenna

Connect the antenna cable to the

TV using one of the methods in the

illustration as shown (,,or).

To TV antenna terminal

Cable TV lead-In

75-ohm coaxial cable (round)

75-ohm coaxial cable (round)

or

300-ohm twin-lead cable (flat)

Home Antenna

terminal (75-ohm)

Home Antenna

terminal (75-ohm)

Coaxial cable

(commercially available)

Coaxial cable

(commercially available)

300/75-ohm adapter

(commercially available)

VHF

ANTENNA

UHF

ANTENNA

300-ohm

twin-lead cable

Combiner

(commercially

available)

300-ohm twin-lead cable

75-ohm coaxial cable

IN OUT

6

1

2

3

or

3BX0131A.indb 12

3BX0131A.indb 12

4/7/2010 6:40:00 PM

4/7/2010 6:40:00 PM

Advertising