Sunrise Medical Wheelchair Quickie S-525 - Manual (Page 6)

11 931156 Rev. A 10 931156 Rev. A
V . S E T - U P , A D J U S T M E N T & U S E
G. CHECK-OUT
Once the tilt assembly is adjusted, it should
actuate smoothly and easily. All accessories
should also perform smoothly.
1. Verify seat can achieve full tilt and will
return to neutral.
2. Verify upper and lower stop blocks
meet (A).
3. Verify the motor cuts out once the neu-
tral position is reached.
4. Verify no debris is interfering with the
glide bearings.
5. Verify all hardware is securely tightened.
6. Verify that the tilt lock-out sensor (
I ) is
positioned in its mount with its wires
leading out toward the front of the chair.
A
c) Tilt the seat to the desired limit.
d) Slide the switch (B) back toward the rear until it comes into contact
with the tilt carriage.
Note: Sliding the switch (B) toward the back of the chair decreases
the tilt limit angle. Sliding the switch (B) toward the front of the chair
increases the tilt limit angle.
Note: A soft, audible click can be heard as the switch arm (B) comes
in contact with the carriage.
e) Use the #1 Phillips screwderiver to tighten the switch to the point
where the switch closes.
Note: Listen for the soft, audible click.
f) Verify that the desired tilt angle has been achieved.
Note: Maximum tilt angle is adjustable to 50°.
F. TM40 SINGLE OR DUAL SWITCH ACTUATOR CONTROLLER
The TM40 actuator controller can be used to activate the tilt mechanism with
either single or dual switch controls.
1, Plug limit switch harness assembly (A) into TM40 limit switch jack (B).
2. Plug single switch (C) into TM40 single switch jack (D) OR plug dual switch
(E) into TM40 dual switch jack (F).
3. Plug TM40 into the QTRONIX Power Module (G) or the Pilot Controller
Communications Connector ( J ).
4. Use mating plugs (H) to connect the TM40 to the tilt actuator.
V . S E T - U P , A D J U S T M E N T & U S E
A
B
A
B
F
D
C
E
H
I
G J
Stereo
Jack
Stereo Jack
Mono Jack