Trouble shooting battery safety information – Sportline Heart Rate Monitor Cardio 660 User Manual

Page 13

Advertising
background image

24

25

Cardio 660 Heart rate Monitor

potentIal causes for no heart rate readIng or long

response tIMe:

cause:

dry skin

solutIon:

apply conductive gel thoroughly to chest area (for

chest-strap measurement). tap water may help if conductive

gel is not available.

cause:

chest strap is not contacting with skin

solutIon:

Make sure the chest strap is firmly over the chest and

the watch is securely on wrist.

cause:

dead or flaking skin on chest.

solutIon:

rub off excessive dead skin with a towel

cause:

a thin layer of body grease insulates the ecG signal pre-

venting the chest strap or watch from detecting ecG heart rate

solutIon:

wipe chest / wrist and the back of chest strap/

watch with a tissue or soft towel.

cause:

Hairy skin

solutIon:

apply conductive gel to chest area or wrist.

cause:

low Battery

solutIon:

replace the battery in watch/transmitter and try

again.

cause:

electrical field interference from rf devices (chest-

strap Measurement) such as overhead power lines, etc.

solutIon:

leave the area where rf source potentially exist.

cause:

issues acquiring heart rate.

solutIon:

try resetting the exercise timer which will tell the

watch to begin acquiring heart rate again (see pg. 16).

solutIon:

Make sure watch and transmitter strap are coded

correctly (see pg. 11).

cautIon – battery safety InforMatIon
• non-rechargeable batteries are not to be recharged
• rechargeable batteries must be removed before recharging
• rechargeable batteries should only be recharged under

adult supervision

• do not mix alkaline, standard (carbon-zinc), or recharge-

able (nickel-cadmium) batteries

• exhausted batteries are to be removed
• do not mix old and new batteries
• do not dispose of product or batteries in fire; batteries may

explode or leak

• if this product will not be used for an extended period of

time, remove the batteries from the product

• the supply terminals are not to be short-circuited
• Batteries are to be inserted with correct polarity
• clean the battery contacts and also those of the product

prior to battery installation

• as always, dispose of batteries in an eco-friendly manner

the purpose of the crossed-out wheelie bin symbol is to remind us

that most electrical products, and batteries, contain trace elements

(including Mercury – Hg, cadmium – cd and lead – Pb) which could

be harmful to our environment and therefore our health. we must all

be careful to dispose of them responsibly in a specifically designated

way – either using a collection scheme or into the correctly labeled

civic amenity (not into general waste) – this will help your local

authority to arrange to recycle or dispose of them in the appropriate

manner.

Trouble shooTing

baTTery safeTy informaTion

www.sportline.com

Advertising
This manual is related to the following products: