Sharp Aquos LC-15B8U-S - Manual (Page 22)

21
CH-SETTING
■ EZ SETUP
When you move to an area with different broadcasting
signals, you may have to set the channel numbers and
the time with the EZ SETUP function. To activate EZ
SETUP, perform the following procedure.
1 Press '/" to select “CH-SETTING” in the SETUP screen (see
page 17), and press ENTER.
2 Press '/" to select “EZ SETUP”, and press ENTER.
3 Press '/" to select “YES”, and press ENTER.
Refer to page 12 for more information on EZ SETUP.
■ Setting the AIR/CABLE
It is necessary to set the receiving mode to AIR or CABLE
channels to receive locally broadcast TV programs.
Press MENU to display the Menu screen.
Press \/| to select “SETUP”.
Press '/" to select “CH-SETTING”, and press ENTER.
Press '/" to select “AIR/CABLE”, and press ENTER.
Press '/" to select the desired setting, and press ENTER.
E Z S E T U P
A I R / C A B L E A I R
C H S E A R C H
C H M E M O R Y C A B L E
Press MENU to exit.
A
• Receivable channels of the LCD TV set are:
AIR channels:
CABLE channels:
VHF: 2 through 13. 1 (HRC and IRC)
UHF: 14 through 69. 2 through 125 (STD, HRC and IRC)
1
4
2
5
3
Useful Features
■ Saving broadcast TV channels in the memory
Press MENU to display the Menu screen.
Press \/| to select “SETUP”.
Press '/" to select “CH-SETTING”, and press ENTER.
Press '/" to select “CH SEARCH”, and press ENTER.
E Z S E T U P
A I R / C A B L E C A B L E 1
C H S E A R C H
C H M E M O R Y
Press ENTER. The tuner will search through all available
channels in your area and add them to the TV memory.
S T E R E O
S A P
M O N O
2
A
• To interrupt CH SEARCH, press MENU RETURN. CH SEARCH will
stop at the current channel and will not add any higher channels.
■ Adding weak or additional channels or erasing
unwanted channels from TV memory
Individual settings of programs can be adjusted.
Repeat steps 1 to 3 of Saving broadcast TV channels
in the memory.
Press '/" to select “CH MEMORY”, and press
ENTER.
E Z S E T U P
A I R / C A B L E C H A N N E L A I R 2
C H S E A R C H S K I P O N
C H M E M O R Y
Press '/" to move the cursor to “CHANNEL”, and use
\/| or Channel Select to select the desired channel to
be added or erased.
Press '/" to move the cursor to “SKIP”, and use \/|
to select “ON” or “OFF”.
Press MENU to exit.
A
• If CH SEARCH is performed again, the previously memorized
channels will be lost.
4
2
5
3
1
4
5
1
2
3
LC15B 8U_E_P18-22.p65 05.3.15, 9:13 AM 21