Snapper 1695064 - Manual (Page 17)

Removing and Reattaching Grass Catcher
15
Installing the Grass Catcher
1. Set the back plate & support (A, Figure 11) on pins of
hitch plate (C). Secure with rod (D) and hair pin (B).
2. Install the bags (C, Figure 12).
3. Install the cover (E, Figure 12). Secure with the cle-
vis pins (F) and hair pin clips (B).
NOTE: Push the hair pin clips all the way on or they will
be bent by the hinge when the cover is opened.
4. Connect the cover cable (Figure 8).
5. Insert the tubes (A, Figure 12) into the catcher and
connect to the turbo. Be sure the clip (F) is secured
over the top of the turbo flange nut.
Figure 11. Install Back Plate (Flat Style Bumper shown)
A. Back Plate & Support
C. Hitch Plate
B. Hair Pin D. Rod
B
A
D
C
Figure 12. Normal Removal & Installation
A. Tubes
B. Hair Pin Clip
C. Bags
D. Clevis Pin
E. Cover
F. Clip
D
E
C
B
A
F