Setting drc (dynamic range compression), Test tone, Setting drc – Samsung HT-AS600 User Manual
Page 13: Dynamic range compression), Remote control, Main unit
24
Test Tone
Use test tone to check the speaker connection status or level.
Press TEST TONE button.
•
Test signal will be automatically output as follows; F.L
➝
CEN
➝
F.R
➝
S.R
➝
S.L
➝
S.W.
•
During test tone output, press
…†
button to adjust the speaker output level
from -10 to +10 dB by 1 step.
To Stop Test Tone
•
Press TEST TONE button again.
√
To Automatically Output Test Tone
REMOTE CONTROL
1
OPERA
TION
Setting DRC
(Dynamic Range Compression)
You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
Press SETUP button.
•
“SETUP MODE” appears on the display and enters into Setup Mode.
Press INPUT button 3 times.
•
“DRC SETUP” appears on the display.
Press SURROUND button to set DRC.
•
Each time you press this button, DRC : STD
➝
DRC : MAX
➝
DRC : MIN will be
selected in turn.
To Exit Setup Mode
•
Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit.
“SETUP MODE OFF” appears on the display and exits Setup Mode.
√
•
STD : Sets DRC effect to standard.
•
MAX : Sets DRC effect to maximum.
•
MIN : Sets DRC effect to minimum.
Setting DRC
MAIN UNIT
1
2
3
23
•
You can only set this function via the main unit.