Spectra Watermakers EVO Series DGP-NE96 User Manual
Spectra Watermakers Hardware
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- 1. See “LED Feedback” on page 1
- 2. 25-Pin Parallel Port: Connect the Printer Module’s 25-pin parallel port to any dot matrix printer. Note: The dot matrix printer must support a minimum of 80 columns.
- 3. 9-Pin Serial Port: Connect the Printer Module’s 9-Pin serial port to a dot matrix printer. Note: The dot matrix printer must support a minimum of 80 columns.
- 4. 9-pin Serial Port: Connect the Printer Module’s 9-pin serial port to a home automation module.
- 5. 9-pin Serial Port: Connect C-Bus to the Printer Module using a null modem cable.
- 6. 9-pin Serial Port: Connect either the Printer Module’s USB or 9-pin serial port to a computer’s COM port to view the control ...
- 2. Enter section [953] (DGP-848) [4003] (EVO)
- 3. Enter module’s 8-digit [serial number]
- 4. Enter [section] and enter the required [data]
- 2. Enter the [installer code]
- 3. Enter 3-digit [section] you wish to program
- 4. Enter the required [data]
- EVO Sections
- Spectra Sections
- EVO Sections
- Spectra Sections
- 1. Click Start (from the Windows® taskbar) a Programs a Accessories a Communications a HyperTerminal®. The Connection Description window is displayed.
- 2. Enter a name in the Name text box and select an icon for your connection file. Click OK. The Connect To window is displayed.
- 3. From the Connect Using drop-down list select the COM port connected to the Printer Module. Click OK. The COM Properties window is displayed.
- 4. Click on the Bits per second drop-down list and select the baud rate that is set in the Printer Module (Section [016] Options [2] & [3]). By default, HyperTerminal® sets the Data bits at 8, the Parity at None and the Stop bits at 1. Click OK.
- 5. The HyperTerminal® display will appear already connected to the Printer Module. Click on the Properties icon (or select Prope...
- Introduction
- Home Automation Interface Capabilities
- Technical Specifications
- Printer Requirements
- LED Feedback