Appendices, Technical specifications, Data connections – Server Technology Sentry Global Security Modem User Manual
Page 14: Telco connection port, Led indicators, Regulatory compliance, Fcc part 15 regulation, Hapter, Ppendices, Appendix a: technical specifications
Chapter 4: Appendices
Appendix A: Technical Specifications
Data Connections
Telco Connection Port
Pin Signal
Name
3 Tip
5
6 4321
4 Ring
LED indicators
The Global Security Modem is equipped with status LED indicators for five serial I/O lines.
Label Serial
I/O
Line
DTR
Data Terminal Ready
DCD
Data Carrier Detect
RI Ring
Indicator
TXD Transmit
Data
RXD Receive
Data
Regulatory Compliance
Safety EMC
EN 60950
EN 55022
UL 1950
FCC Part 15
IEC 950
Canadian
EMC
AS/NZ 3260
EN 55024
TS-001 GB
4943,
GB
9254
CCIB (China)
FCC Part 15 Regulation
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Plug the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
12
• Appendices
Sentry Global Security Modem
Installation and Operations Manual