2 washing programs, User instructions – Smeg ST115S User Manual

Page 13

Advertising
background image

User instructions

12


3.2 Washing programs

Before starting a washing program make sure that:

The water supply tap is open.

The correct amount of detergent has been added to the
dispenser.

The baskets have been correctly loaded.

The spray arms are able to rotate freely and without
obstruction.

The dishwasher door is securely closed.


SELECTING HALF LOAD WASH
(available in all programs except the soak program)

This function is ideal for small loads and saves water and electricity. It is
controlled by the HALF LOAD button (6) and allows washing in the upper
basket only.
IMPORTANT: at the end of the program remember to deactivate the
function
to ensure the next wash is not also carried out in half load mode
by mistake.

A cutlery basket can be placed in the upper basket, while the lower
basket must be left empty
.

CAUTION: there is no point in loading dishes and cutlery in the
lower basket, since the jet of water will only reach the upper basket.

DELAYED START
(available in all programs except the soak program)

The start of the program can be delayed by 3, 6 or 9 hours.
This allows you to set the dishwasher to work at the times of day most
convenient to you.
After setting the program of your choice, press the DELAYED START
button (8) to select the delay you require. The corresponding DELAYED
START
light (9) lights up.
If you wish to exit the procedure without setting delayed start, press the
button in sequence until all three lights are out.
At the end of the cycle, the procedure is automatically deleted, so if you
also require it for the next program you will have to set it again.

Advertising