Sony PCS-G70 FAQ - Manual (Page 12)

PCS-G50 and PCS-G70 Video Communication Systems
6 FAQ
Q. What is the control API for the PCS-G50/G70 system.
A. Download the control API from:
http://www.sony.com/videoconference
You can control the system from a touch panel controller (such as
Crestron, AMX) via RS-232C or Telnet.
Q. How do I use the IR repeater?
A. Use the IR repeater to power on the Sony TV and change video
input to Video-1. Select IR repeater mode in the general setup
menu (Mode1 or Mode2 for NTSC TVs).
You can also use the IR repeater to power on Sony projectors.
Enter the PROJ command on the service command entry. Refer to
the release notes for details.
Q. Where do I connect the IR receiver?
A. Connect the IR receiver to the Control-S terminal on the back of
the communication terminal or the camera conversion adaptor. If
you connect it to the Control-S terminal, the IR receiver inside the
PCSA-CG70 or PCSA-CTG70 cameras are invalid.
Q. How do I use the conversion cable?
A. Connect the video conversion cable to the video AUX input
terminal.
Connect the RCA video cable to the communication terminal.
Connect the S-Video cable directly to the video AUX input terminal.
CAMERA FAQ
Q. Does PCS-G50/G70 support tracking cameras?
A. PCS-G70 supports the PCSA-CTG70 tracking camera; however,
PCS-G50 does not support a tracking camera.
Q. What modes does the tracking camera support?
A. The PCSA-CTG70 tracking camera uses voice activate and face
recognition technologies, and supports three different modes:
Speaker tracking mode, Next face centering mode, and Presenter
mode.