Schumacher Automatic Battery Charger / Maintainer SC-200A - Manual (Page 6)

• 6 •
Never place the charger directly above the battery being charged; 4.2
gases from the battery will corrode and damage the charger.
Do not set the battery on top of the charger. 4.3
Never allow battery acid to drip onto the charger when reading the 4.4
electrolyte specific gravity or filling the battery.
Do not operate the charger in a closed-in area or restrict the 4.5
ventilation in any way.
dC CONNECTiON PRECAUTiONS
5.
Connect and disconnect the DC output clips only after setting 5.1
all of the charger switches to the “off” position (if applicable) and
removing the AC plug from the electrical outlet. Never allow the
clips to touch each other.
Attach the clips to the battery and chassis, as indicated in sections 5.2
6 and 7.
FOLLOW THESE STEPS WHEN BATTERY iS iNSTALLEd
6.
iN VEHiCLE.
A SPARK NEAR THE
BATTERY MAY CAUSE A
BATTERY EXPLOSiON. TO
REdUCE THE RiSK OF A
SPARK NEAR THE BATTERY:
Position the AC and 6.1
DC cables to reduce the risk of damage by the hood, door and
moving or hot engine parts. NOTE: If it is necessary to close the
hood during the charging process, ensure that the hood does not
touch the metal part of the battery clips or cut the insulation of the
cables.
Stay clear of fan blades, belts, pulleys and other parts that can 6.2
cause injury.
Check the polarity of the battery posts. The POSITIVE (POS, P, 6.3
+) battery post usually has a larger diameter than the NEGATIVE
(NEG, N, -) post.
Determine which post of the battery is grounded (connected) to 6.4
the chassis. If the negative post is grounded to the chassis (as in
most vehicles), see step 6.5. If the positive post is grounded to the
chassis, see step 6.6.