Star Trac IP-S6331 - Manual (Page 5)

Page 5
INSTALLING THE ARM PIVOT BRACKET:
1. Locate the six (M12,70MM,Button Head
Bolts), six (M12,Washers), ARM
BRACKET, & ARM PIVOT BACK
PLATE. Align components and tighten
bolts using an 8MM hex key.
2. Secure the ARM BRACKET CROSS
BRACE to the FRONT TUBING with four
(M8, 20MM, Button Head Screw) and
four (M8, Washers). Tighten with a 4MM
hex key.
Back
Plate
Cross
Brace
Arm Pivot
Bracket
INSTALLING THE ARM PIVOT:
1. Place the ARM PIVOT assembly in
between the ARM PIVOT BRACKET and
align with the PIVOT SHAFT.
2. Install END CAPS as shown with a M8
Washer and (M8, 20MM, Socket Head
Screw) on each side. NOTE: Place the
END CAP with the red rotational sticker
toward the user.
Arm
Pivot
Pivot
Shaft
End Cap w/
Red Sticker
Spacer w/
25mm ID
Spacer w/
8.4mm ID
2X M8
Washer