ScyTek Electronics G20 - Manual (Page 9)

Page 8 - G25/G20 G25/G20 - Page 8
Entering System Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
· The siren will provide one long chirp, indicating that you have entered Programming.
3. Press the valet switch the number of times equal to the System Parameter you want to change.
· The siren will chirp each time the valet switch is pressed.
4. Within 5 seconds, press the transmitter button corresponding to the desired operating mode for
that System Parameter.
· The siren will chirp to indicate the setting.
1 chirp = Button 1
2 chirps = Button 2
3 chirps = Button 3
5. When you are finished, turn off the ignition to save the changes.
Default Reset
Following this procedure will set all System Programming Parameters to factory default settings.
1. Enter System Programming.
2. Press Transmitter Button 3.
· The siren will chirp 6 times indicating that the reset signal was received.
· All System Programming parameters are now set to factory default settings.
· The Valet Mode is off.
3. Turn off ignition.
Programmable System Options
System Programming
Branch Feature Button 1 (default) Button 2 Button 3
1. Horn Chirps w/ Arm&Disarm Horn Chirps Disabled Horn Chirps Enabled Horn Chirps w/Warn
2. Arm Mode Manual Arming Passive Arming Passive w/Countdown
3. Passive Door Locking Disabled Enabled Set Override Code
4. Ignition Controlled Locks On Off Lock Only
5. Door Input Monitoring 10 Seconds 60 Seconds
6. Auto Rearming Disabled Enabled
7. Door Unlock Pulse Single Double
8. Arming Chirps Normal Silent
9. Extended Parking Lights On Off
10. Disarm with Aux 1 Disabled Enabled
11. Door Lock Pulse Length 1 Second 3 Seconds 0.1 Seconds
12. Anti-Carjack Mode Disabled Enabled
13. Anti-Carjack Type Manual Passive Full-time
14. Ignition Armed Mode Disabled Enabled
15. Interior Light Mode Interior Light 30Sec Windows 10Sec Windows 30Sec
16. Interior Light Output (G25) Interior Light Auxiliary 2