SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 183)

P
ORT
C
ONFIGURATION
3-127
Command Attribute
Rate Limit – Sets the output rate limit for an interface.
Default Status – Disabled
Default Rate – 1000 Mbps
Range – 1 - 1000 Mbps
Web - Click Rate Limit, Input/Output Port/Trunk Configuration. Set the
Input Rate Limit Status or Output Rate Limit Status, then set the rate limit
for the individual interfaces, and click Apply.
Figure 3-59 Rate Limit Configuration
CLI - This example sets the rate limit for input and output traffic passing
through port 1 to 600 Mbps.
Showing Port Statistics
You can display standard statistics on network traffic from the Interfaces
Group and Ethernet-like MIBs, as well as a detailed breakdown of traffic
based on the RMON MIB. Interfaces and Ethernet-like statistics display
errors on the traffic passing through each port. This information can be
used to identify potential problems with the switch (such as a faulty port or
Console(config)#interface ethernet 1/1 4-174
Console(config-if)#rate-limit input 600 4-191
Console(config-if)#rate-limit output 600
Console(config-if)#