SMC Networks SMC TigerStack 1000 SMC8748M User Manual
Tigerstack 10g, Gigabit ethernet switch, Management guide
Advertising
TigerStack 10G
Gigabit Ethernet Switch
◆ 24/48 auto-MDI/MDI-X 10/100/1000BASE-T ports
◆ 4 ports shared with 4 SFP transceiver slots
◆ Non-blocking switching architecture
◆ Support for a redundant power unit
◆ Spanning Tree Protocol, RSTP, and MSTP
◆ Up to 32 LACP or static 8-port trunks
◆ Layer 2/3/4 CoS support through eight priority queues
◆ Layer 3/4 traffic priority with IP Precedence and IP DSCP
◆ Full support for VLANs with GVRP
◆ IGMP multicast filtering and snooping
◆ Support for jumbo frames up to 9 KB
◆ Manageable via console, Web, and SNMP/RMON
Management Guide
SMC8724M
SMC8748M
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1 Introduction
- Chapter 2 Initial Configuration
- Chapter 3 Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Basic Configuration
- Displaying System Information
- Displaying Switch Hardware/Software Versions
- Displaying Bridge Extension Capabilities
- Setting the Switch’s IP Address
- Managing Firmware
- Saving or Restoring Configuration Settings
- Console Port Settings
- Telnet Settings
- Configuring Event Logging
- Renumbering the Stack
- Resetting the System
- Setting the System Clock
- Simple Network Management Protocol
- User Authentication
- Access Control Lists
- Port Configuration
- Address Table Settings
- Spanning Tree Algorithm Configuration
- VLAN Configuration
- Class of Service Configuration
- Multicast Filtering
- Configuring Domain Name Service
- Chapter 4 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- Line Commands
- General Commands
- System Management Commands
- Flash/File Commands
- Authentication Commands
- Access Control List Commands
- SNMP Commands
- DNS Commands
- Interface Commands
- Mirror Port Commands
- Rate Limit Commands
- Link Aggregation Commands
- Address Table Commands
- Spanning Tree Commands
- spanning-tree
- spanning-tree mode
- spanning-tree forward-time
- spanning-tree hello-time
- spanning-tree max-age
- spanning-tree priority
- spanning-tree pathcost method
- spanning-tree transmission-limit
- spanning-tree mst configuration
- mst vlan
- mst priority
- name
- revision
- max-hops
- spanning-tree spanning-disabled
- spanning-tree cost
- spanning-tree port-priority
- spanning-tree edge-port
- spanning-tree portfast
- spanning-tree link-type
- spanning-tree mst cost
- spanning-tree mst port-priority
- spanning-tree protocol-migration
- show spanning-tree
- show spanning-tree mst configuration
- VLAN Commands
- GVRP and Bridge Extension Commands
- Priority Commands
- Multicast Filtering Commands
- IP Interface Commands
- Appendix A Software Specifications
- Appendix B Troubleshooting
- Glossary
- Index