Sony MKS-2010 - Manual (Page 156)

156
Basic Settings
Ch
a
p
te
r
9
Sys
te
m
Set
tin
gs
• PGM (program signal): final output signal including
the downstream key
• PST (preset signal)
• PGM Clean (program clean signal): final output
signal excluding the downstream key
• DSK PVW (downstream key preview signal) or
DSK Key Out (downstream key output signal): The
display varies depending on the setting of [DSK
PVW] in the Output Assign menu.
• AUX1 (auxiliary 1 signal) to AUX4
• EDIT PVW (edit preview signal)
• No Assign: no signal assigned.
4
Select the output signal to be assigned to the output
port selected in step 2.
This makes the signal assignment.
To the right of the output port number selected in the
status area of the Output Assign menu is shown the
name of the assigned output signal.
Note
Depending on the signal, the name shown in the popup
window and the name shown in the status area of the
Output Assign menu may be different.
Switching M/E PVW or PST output to DSK
PVW output
By pressing the DSK PVW button in the downstream key/
fade to black control block, you can temporarily switch M/
E PVW output (1 M/E panel) or PST output (1.5 M/E
panel) to DSK PVW output.
Notes
• This function is not available when [DSK PVW Btn] is
set to Disable. Press [DSK PVW Btn] to set it to Enable.
• This function is not available when DSK Key Out is
selected instead of DSK PVW.
Assigning Signals to Cross-Point
Buttons (Operation Menu)
Each cross-point button in the M/E cross-point control
block, PGM/PSTcross-point control block (using a 1.5 M/
E panel or 1.5 M/E wide panel), and AUX bus control
block has two numbers. Select which of these numbers is
valid by toggling the dedicated [SHIFT] buttons above
cross-point button rows on or off.
Note
The dedicated [SHIFT] button does not light and does not
function when you are using the rightmost buttons in the
cross-point button rows (the 12th or 20th buttons) as
[SHIFT] buttons.
For more information about how to use the rightmost
buttons as [SHIFT] buttons, see “To use the rightmost
buttons in cross-point button rows as [SHIFT] buttons
(shift mode selection)” (page 158).
Button numbers of cross-point buttons
In the M/E cross-point control block, PGM/PSTcross-
point control block (using a 1.5 M/E panel or 1.5 M/E wide
panel), and AUX bus control block, the button numbers of
the cross-point buttons are as shown in the following
figure.
For the cross-point buttons in all control blocks, the same
signal is assigned to the same button number. The numbers
of all of these buttons differ depending on whether the
dedicated [SHIFT] button is on or off. The numbers also
differ depending on whether the rightmost buttons in
cross-point button rows are being used as [SHIFT] button
(shift mode). See page 158 for more information about
shift mode.
Signal name
shown in the
popup window Signal name shown in the
status area of the Output
Assign menu
M/E Key PVW M/E K-PVW
M/E Key Out M/E Key
M/E PGM Clean M/E PGM CLN
PGM Clean PGM CLN
DSK Key Out DSK Key