Sony MKS-2010 - Manual (Page 187)

Ch
ap
te
r 9
Sys
tem Set
tings
187
Other Settings
2
Press [New], turning it on, then turn the knobs to set
the following parameters.
3
Press [Set].
A new tally copy setting based on the settings made in
step 2 is added.
To modify tally copy settings
1
If [New] is on, turn it off.
2
Using any of the following methods, select the setting
to change.
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knob.
3
Turn the knobs to set the following parameters.
4
Press [Set].
To sort tally copy settings
1
Select a copy setting by carrying out steps 1 and 2 of
“To modify tally copy settings,” then press [Sort].
A popup window appears.
2
Select one of the following to execute the sort.
From Source: Sort in ascending order (smallest first)
by From Source name.
To Source: Sort in ascending order by To Source
name.
To delete tally copy settings
Select a copy setting by carrying out steps 1 and 2 of “To
modify tally copy settings,” then press [Delete].
External Device Connection Port
Setup (Device Menu)
To control external devices connected to the RS-422A 9-
pin serial ports of the DCU, use the Device menu to make
port settings.
See “Controlling External Devices” (page 146) for more
information about controlling external devices.
Assigning devices to DCU ports
1
From the top menu, select Setup/Diag >Device >Port
Assign.
The Port Assign menu appears. The status area shows
a list of devices currently assigned to ports, together
with information about how they are controlled.
Device control settings are made in the Device Assign
menu. For details, see page 188.
2
Using any of the following methods, select the target
port for a device assignment.
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knob.
Knob Description Setting values
1 (CP FR (FR)) Copy-from source
start address
1 to 1024
2 (CP FR (To)) Copy-from source
end address 1 to 1024
3 (CP To (FR)) Copy-to source start
address 1 to 1024
Knob Description Setting values
1 (No) Copy setting selection 1 and upwards
Knob Description Setting values
2 (CP From) Copy-from source 1 to 1024
3 (CP To) Copy-to source 1 to 1024