Salton, Inc BL-1042 - Manual (Page 5)

HELPFUL HINTS
• Prepare solid ingredients by cutting into small pieces 1” – 1-1/4”
(2 – 3 cm). Add a small amount of liquid and place small portions into
the Blender Jar instead of a large quantity all at once. Gradually add
more liquid through the Filler Cap opening.
• Allow hot liquids to cool to a lukewarm temperature before processing.
• Always place your hand on top of the Lid when operating.
• When chopping nuts or other dry mixtures use 3/4 cup (180 ml) at a time,
to ensure even chopping.
• While the motor is running, ingredients can be added through the Filler
Cap opening in the center of the Blender Lid.
• To crush ice, place the ice cubes into the Jar with the motor switched off.
Close the Lid and press the ‘ICE CRUSH’ setting. Add a little water through
the Filler Cap opening for more even ice crushing.
• DO NOT operate the Blender for more than 90 seconds when processing
dry ingredients.
• DO NOT run the Blender when empty
CARE AND CLEANING
1. Unplug from wall outlet.
2. Remove Blender Jar from Blender Base. Wipe the Blender Base with a damp
cloth. If necessary, you can use a little mild detergent. DO NOT IMMERSE
IN WATER OR ANY OTHER LIQUID.
3. Empty the Blender Jar completely. Rinse the inside with water, then remove
the plastic Jar Base and Cutting Blade Assembly by turning the Jar Base
counterclockwise.
4. Remove the Cutting Blades and gasket. NOTE: Be careful when handling
the Cutting Blade Assembly, the blades are sharp.
5. Wash the Blender Jar, Lid, Filler Cap, Jar Base, Gasket and Cutting Blades
in warm soapy water. Rinse and dry.
5
SAL7-555 Booklet Blender Salton BL-1042 _EN VF.qxd 12/06/07 16:55 Page 5