Samsung Model RS27KLMR - Manual (Page 29)

29
INST
ALLA
TION INSTR
UCTIONS
INSTALLING THE WATER DISPENSER LINE
COMPRESSOR COVER OF
REFRIGERATOR
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
CONNECTION NUT
WATER LINE
CLIP A
WATER LINE
- Using clip ”A”, fix the water line to the wallor (the back of
refrigerator).
- When the water line is secure, make sure whether the
water line is not excessively bent, pinched or squashed.
Complete the installation of the water supply line.
- Power on the refrigerator and press the lever on the right of the
dispenser until water runs out through the water line and all air has been empty.
- At this time, check for any possible leakages at the join point in the water line.
After securing the water line, move the refrigerator to the required location.
Once the refrigerator is in position, do not move possibly.
Install the water filter.
Connect the water line to the refrigerator.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
COVER FILTER
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
Caution
Please check if the indication line aligns with the lock position.
- As shown, separate the fixed cap in the refrigerator by rotating
it counterclockwise.
Remove the water filter from the box and put a month indicator
sticker on the filter as shown.
- Write the month you installed the filter on the label.
EX) If the water filter was installed in March, put “MAR”
- Remove the protective cap then position and insert the filter as shown,
- Slowly turn the water filter clockwise 90º to align the indication mark on the
cover, locking the filter in postion. Do not overtighten.
Secure the water line.