Smart Technologies Smart Board 2000i - Manual (Page 7)

99-00496-00 REV A0 Projector Replacement Guide for the 2000i 3
6. Set the projector down on a flat surface and remove the projector plate from the projector:
Using the provided hex key, loosen and remove the four sets of screws, spacers and
washers at the corners of the plate.
7. Transfer the plate to the new projector and attach it using the same screws, spacers and
washers that were removed in the previous step.
Cap Screw
Lock Washer
Flat Washer
Aluminum Spacer