Sanyo IDC-1000ZU User Manual
Page 80
4
Press the SET button.
œ
This completes the voice memo setting.
œ
The voice memo setting indicator appears in the right
side of the monitor.
œ
The voice memo setting returns to voice memo off if
the mode selector dial is turned, the CAMERA/PLAY
switch is changed, or the digital disk camera is turned
off.
œ
To exit the Still Image Shooting Setting Screen, press
the MODE button.
œ
Even after the Still Image Shooting Setting Screen is
exited, the voice memo setting indicator
}
will remain.
5
Press the shutter release button.
œ
The image is captured and then the voice memo is
recorded.
œ
While the voice memo is being recording, the
b
icon
will appear in the monitor.
œ
Up to a maximum of 10 seconds can be recorded.
œ
To stop the recording before the 10 seconds elapses,
press the shutter release button again.
œ
If the shutter release button is not pressed, then the
maximum 10 seconds will be recorded.
œ
Even after the recording is finished, the voice memo
on settings remains unchanged.
NOTE
œ
The voice memo sound file takes up approximately one-half the disk space required by one
image with resolution
P
and compression ratio
U
.
œ
Besides using the built-in microphone, you can also record the voice memo by connecting the
supplied microphone to the MIC input terminal. Be aware that the built-in microphone will not
work when a microphone is connected to the MIC input terminal (see page 49).
100-0001
Voice memo setting indicator
Shutter release button
Microphone
1/1000
11.0
79
English