SIIG 04-0202A - Manual (Page 2)

2
Package Contents
• One Low Profile PCI I/O board
• One Driver Installation diskette
• One 5-year warranty card
• This quick installation guide
Hardware Installation
General instructions for installing the card are provided below,
since the design of computer cases and motherboards vary. Refer
to your computer’s reference manual for further information, if
needed.
Static Electricity Discharge may permanently damage your system.
Discharge any static electricity build up in your body by touching
your computer’s case for a few seconds. Avoid any contact with
internal parts and handle cards only by their external edges.
1. Turn OFF the power to your computer and any other
connected peripheral devices. Unplug the computer's power
cord.
2. Remove your computer’s cover and install the card in an
available PCI slot.
3. Push the board down firmly, but gently, until it is well seated.
4. Secure the card and replace the cover.
Software Installation
This section provides information on how to install the
Low Profile PCI I/O's drivers for the following operating systems:
Windows 95/98/98 SE/ME
Windows NT 4.0
Windows 2000
DOS/Windows 3.1x
Windows 95:
1. At the Add New Hardware Wizard windows, click Next.
2. Insert the Driver Installation diskette in the floppy drive, and
click Other Locations. Type in a:\Win95, click OK, then
Finish.