Philips Saeco MAC 2002 - Manual (Page 6)

courtesy of
12
FIRST-TIME USE
Do not place or submerge the coffee maker in water or
other liquid.
Do not force open the coffee grinder, and do not open
the housing of the grinder.
Storage
When not needed, turn off appliance and disconnect
the plug from the power source.
Store the grinder in a place that is not accessible to
children.
Service
If the grinder malfunctions, or is defective, or damage
is suspected, immediately disconnect the plug.
Do not operate a defective appliance.
Do not force open the grinder and do not open the
housing of the grinder.
Repair only should be done by an authorized Saeco
service facility.
The manufacturer shall not be liable for any
consequential damages after non-authorized repair.
Fire prevention
In case of fire, use carbon dioxide (CO
2
) extinguishers
only. Do not use water or powder distinguishers.
Controls and features
Coffee bean hopper
Lid, bean hopper
Grind adjusment ring
On/off switch
Release button for ground coffee container
Doser
Doser lever
Ground coffee container
Accessories
Coffee measuring scoop
4 FIRST-TIME USE
Carefully unpack your grinder being certain to remove
all literature and packing material.
For personal safety and the safety of others,
observe the Important Safety Instructions in
section 3.
4.1 Packing material
The original packing was designed to protect the coffee
grinder during shipment..
Save the carton and packing material in case you need
to return your appliance for service.
4.2 Installation safety instructions
Observe the following safety instructions:
• Place the appliance on a flat, stable surface.
• Ensure that the coffee grinder is not accessible to
children.
• Do not place the grinder on a hot surface, or near a
gas or electric range.
The grinder is not ready for connection to the power
supply.
4.3 Power supply
Electric shock can kill. Do not immerse
cord, plug, or appliance in water or other
liquid.
Do not touch live electrical components. This can result
in electric shock. Electric shock can cause serious injury
or death.
Connect the appliance only to an electric power source
that corresponds to the voltage indicated on the
appliance data plate.
4.4 Connection to power supply
• Before connecting to the power supply, ensure that
the On/Off switch is in the “O” position.
• Connect power cord plug to the receptacle.
4.5 Filling coffee bean hopper
Warning!
Ensure that the On/Off switch (4) is in the
“O” position before when filling the coffee bean
hopper with coffee beans.
• Using light pressure, set coffee bean hopper into
position on grinder.
• Remove lid (2).
• After ensuring that hopper is clean, fill with fresh
coffee beans.
• Replace lid (2) onto hopper.