Sanyo PLC-XE33 - Manual (Page 23)

PLC-XE33 Basic Serial Command Specifications
22/22
7.7. Setting Read Command
Command “CR4” [CR]
Detail Get screen setting status such as Ceiling / Rear.
Response
Acceptable “%1” [CR]
%1
“11”[CR] = Normal Screen Setting
“10”[CR] = Picture is top/bottom reversed.
(Status: Rear Ceiling ON)
“01”[CR] = Picture is left/right reversed. (Status: Rear ON)
“00”[CR] = Picture is top/bottom and left/right reversed.
(Status: Ceiling ON )
Unacceptable “?” [CR]
7.8. Temp Read Command
Command “CR6” [CR]
Detail
Get the temperature data inside the projector.
With some temperature sensors installed in the projector, it is possible to get all
the temperature at once.
Response
Acceptable “%1_%2_%3” [CR]
%1
%2
%3
%1 Temperature of sensor 1
%2 Temperature of sensor 2
%3 Temperature of sensor 3
Temperature data is shown as “00.0”.
When the temperature goes down to -, the first character
becomes “-” instead of a space, like “-05.5” [CR].
When no temperature data can be returned due to hardware
problems, the first character becomes “E” like”E00.0” [CR].
When several temperature sensors are equipped, Responses are
returned continuously.
“_31.5 _ _35.2 _ _33.4”[CR]
The first data is sensor 1, then one space, and the data of sensor
2 follows.
Unacceptable “ ”[CR]
7.9. Lamp Mode Read Command
Command “CR7” [CR]
Detail
Get lamp mode status.
For 1 lamp projector, get if it is lighting or not.
Response
Acceptable “%1” [CR]
%1
“00” [CR]=Light is out.
“01” [CR]=Light is on.
Unacceptable “ ”[CR]